Problem in getting jitter from phase noise of pll

kooller

Hi all,

I'm recently doing the jitter simulation of PLL, and I first got phase noise of PLL by adding every part of noise of PLL.
/ H1 D+ c& t: W/ I" A7 ?
2 r, o& ?; Y* X9 b% @2 n( MThen calculate jitter by the following formula:
2 U  M' \4 N& O. |- B
phase jitter = sqrt(integral(fre,2*Lpll))/(2*pi*f);
" S' j4 \+ Z+ lperiod jitter = sqrt(8*integral(fre,Lpll.*(sin(pi*fre*T)).^2)/((2*pi*f)^2));
" @; s7 Y: L) c
Frequency of PLL is 5GHz, and the integral band of phase noise is 100Hz~100MHz, phase noise of PLL is as follows: -85dBc/Hz @100Hz; -64dBc/Hz @100kHz; -80dBc/Hz @1MHz; -102dBc/Hz@10MHz; -125dBc/Hz@100MHz.
5 p1 b; t3 }0 F/ z0 ^" D
, I* A8 N! C& D; |, L& v2 D. eThe calculated jitter results is :
phase jitter: 18.9ps.
/ R4 E+ C; ^+ O# S( D  n- s- Dperiod jitter: 0.04ps.

This shows that the period jitter is so small, and only 1/450 times of phase jitter, while our test results shows that the period jitter is about 1.8ps.
7 a. M% t3 ]8 j+ R7 [
So can somebody tell me where is the problem of my calculation, and how much will phase jitter larger than period jitter?

anita66

看您的PN那麼差,jitter應該不可能不到20ps,其實PN是ㄧ個積分所得到的數值,同樣,jitter換算回來時,也是要累加才對,所以,你的算法有問題,可以再找一下正確的計算公式,3Q~