about dbm/200khz problem..

super

Dear all :
               The doc spec write as below ,
                   Frequency         Emission Level
, \( }! s* R/ P/ Z; @7 g, `                2Mhz to 50Mhz    -30dbm/200khz

. R# J% Y  P* ]) c             1. what's it mean ?
) c3 r; H, s3 V4 E5 R             2. How should I do when I measure spurious use Spectrum Analyzer ?
            (ex: set RBW=200khz  and measured spurious below -30dbm is pass ?
                   or others )

* M1 W' I* H/ ]/ I. v5 E
              Thanks.

cqmyg5

I'm not an expert, I think "set RBW=200khz  and measured spurious below -30dbm is pass" is correct.
0 Q7 Q$ v5 s0 HI know another spec: -40dBm/1MHz, that's to measure dBm per 100k(RBW=100k)., then sum(10), if below -40dBm is pass.

super

Dear sir :
           Thanks your reply.
$ i) j% F5 K" m' e8 }' u+ }; ?. M            To confirm again ,
          1. It means when I measure use Spectrum Analyser I need to set
              RBW=200Khz start=2Mhz stop=50Mhz,
$ u, ~0 F9 L3 b: x9 |! {8 |' t             if measured power level >-30dBm then it's fail , <-30dBm it's pass.
7 v: s4 ?. ~5 g6 ^3 t. c, n# {6 r              Right ?

          2. But my boss tell me it's need below -70dbm not -30dbm , I don't know why.
' Z8 V4 d# o, \             If I transfer it to dbm/hz is -83dmb/hz ,it become more severe than -70dbm
. Z' E5 }  S/ W# x+ X2 C  M8 O             and unit also different.
             I don't know which part is wrong ?

& I3 n5 m* \  M/ p) g3 t0 d, J           Thanks.