要trace layout上的power line?

camilla

各位前輩,

   我實驗室是使用.18um 1p3m的製程。 學長今天出了一道問題給我,
要我寫一個command file去把layout裡的vdd全抓出來,方便他檢查
我畫的layout,但在有轉層的地方,不要顯示via出來,只希望在執行完我
寫的command file後只會出現metal1、metal2及metal3。
   但我今天試了很久還是試不出來,不知道有無前輩們是否也寫過類似的
2 x" M7 V: H- I5 c- L6 Jcommand file呢?希望能給小妹一點意見,或者有無相關data能參考...。

9 _& H8 e9 P( |8 q3 Q麻煩各位前輩了~謝謝~

veteran

妳最好註明是哪個軟體用的Command file。這樣別人比較好幫妳..

camilla

各位前輩,不好意思忘記註明軟體了,我是使用calibre ,麻煩大家了

shkao0201

試試 Net 指令
" M1 h4 n% y* n! wLayer operation
NET layer name [… name]
; F7 |- Q& l. z7 c4 CParameters
9 p  N% E4 Y. \0 p• layer
A required original layer or layer set, or a derived polygon layer.
• name
A required name of a net, which can contain one or more question mark (?) characters. The
9 ^( `3 `" M2 P: @? is a wildcard character that matches zero or more characters. You can specify name any
* {! J5 w8 o- w+ b. v" cnumber of times in one statement. The name can be a string variable (see Variable).
Description
Selects all layer polygons that belong to the net having the specified name. To avoid ambiguity,
  }, ]# P8 j0 {& f  kyou must use the parameters in layer name order.
Note
Do not use this operation to obtain net shorting information. The Net operation uses net
names assigned by the connectivity extractor. If the connectivity extractor encounters
shorted nets, it assumes it has found a single net, and assigns it one name.
The connectivity on layer must be established through a connectivity operation.
, Z0 i7 q, r( x& u7 e! ESee also Not Net, Net Area, Connect, Sconnect, and Stamp.
4 `, Z- q& y, P  IExamples
' s  Q; z+ I: \+ e# C% w- o% oMETAL_SP {
5 m# [0 r! ^# w" G# e@ VDD metal must be spaced at 4.5 microns
@ VCC metal must be spaced at 4 microns
* u' x8 ?- t* E  x8 Ovdd_metal = metal net vdd
vcc_metal = metal net vcc
external vdd_metal < 4.5
external vcc_metal < 4.0

james65chan

VCCA_M1 { NET mt1i VCCA } DRC CHECK MAP VCCA_M1 16 0 VCCA.gds

semico_ljj

谢谢了,实用