請問用NI連接agilent 儀器, 需要安裝Agilent I/O Libraaries 15.0?

lhtlht888

請問用NI連接agilent 儀器,  需要安裝Agilent I/O Libraaries 15.0?
. i& u  T% l# t1 x+ R我使用NI的USB to GPIB連接器, 欲透過NI控制Agilent 34970,

chouaries

不用 相反的
你要安裝 NI VISA 或 IEEE488.2 DRIVER 在你的 PC上
# r  w5 I6 t- M; M  N再將USB 連到你的 PC
另一端 GPIB 連到 AGLIENT 的 GPIB PORT 即可

chip123

以下是來自 Agilent 工廠的回覆: FYI~

% R& e5 ^4 x( V. I, tRegarding your question: “請問用NI連接agilent 儀器, 需要安裝Agilent I/O Libraaries 15.0?”, do you mean you use NI GPIB card to connect with the instrument or you want to use NI labview to control the instrument?
/ _' y! p) R5 H" Y
If you use VEE to control the instrument and use NI GPIB card to connect with the instrument, if you use VEE 8.5, you don’t need to install IO 15.0, just install NI visa will be ok; for any pre-8.5 version, you need to install IO 15.0.

; u9 R" s2 t) _: W& n9 i% [; u& VIf you use NI labview to control the Agilent Instrument, you also don’t need to install 15.0.
, G7 D  E6 P4 ]5 t  B& k& n
This is Grace HAN, VEE support engineer.  

Regarding your question: “請問用NI連接agilent 儀器, 需要安裝Agilent I/O Libraaries 15.0?”, do you mean you use NI GPIB card to connect with the instrument or you want to use NI labview to control the instrument?  
* M" ^# w* Z7 m& i7 O
5 S) C# Y; z5 |8 x- q3 @: lIf you use VEE to control the instrument and use NI GPIB card to connect with the instrument, if you use VEE 8.5, you don’t need to install IO 15.0, just install NI visa will be ok; for any pre-8.5 version, you need to install IO 15.0.

) Q5 ?8 H7 _* v/ oIf you use NI labview to control the Agilent Instrument, u also don’t need to install 15.0.