Chip123 科技應用創新平台
標題:
Astro offset 設定
[打印本頁]
作者:
winglee
時間:
2013-11-20 02:30 PM
標題:
Astro offset 設定
我要設定 Astro routing 的 offset 該如何做,條件如下:
+ v4 O8 ]7 R% M( I
1.cell high is 14.7um
: p6 w% ]( A* ]
2.process is 0.5um
. }' {( \: B2 O! j( \+ {4 L6 c
3.grid is 1.3um
# S3 C9 e3 `$ w; C- f& |
4.單一 cell power line is 2.8um,希望在 offset 後,power 重疊為 3um
/ j$ M: B* }% x- w
麻煩版上的朋友們協助一下..
3 L" _6 ]; d9 d4 o- Q% o
謝謝
9 t" n0 N, b8 o. H3 W
歡迎光臨 Chip123 科技應用創新平台 (http://chip123.com/)
Powered by Discuz! X3.2